TY - JOUR AU - Suhendra, Tonny AU - Uperiati, Alena AU - Purnamasari, Dwi Amalia AU - Yunianto, Anton Hekso PY - 2018/10/31 Y2 - 2024/03/29 TI - Kendali Kecepatan Motor DC dengan Metode Pulse Width Modulation menggunakan N-channel Mosfet JF - Jurnal Sustainable: Jurnal Hasil Penelitian dan Industri Terapan JA - sustainable VL - 7 IS - 2 SE - Articles DO - 10.31629/sustainable.v7i2.701 UR - https://ojs.umrah.ac.id/index.php/sustainable/article/view/701 SP - 78-85 AB - <p>The DC motor is one component of robot, the main function of a DC motor is as a driver, whether it's a legged robot or not, as used in a mobile robot. DC motor control is necessary to be one thing that must be considered, because if the motor does not run properly, it will renew the purpose of the motor when it is created. The ability to control a DC motor is needed when building a robot. Many things can affect a person’s ability to design DC motor controller, one of which is the development of science, especially computer science, the use of algorithms to achieve the effectiveness of DC motor movements is very necessary today, so that the robot can move well and according to what is desired. The algorithm requires some information from the system that is built either as input or output so that the algorithm can perform the control process properly. in this study the motor speed controller circuit has been designed using transistor IR630 (n-channel mosfet), in this study the motor speed controller circuit has been designed using transistor IR630 (n-channel mosfet), the potentiometer is used as an analog input on the microcontroller and then converted to a PWM signal which will be used as input to the controller circuit to drive a DC motor. In the tests that have been carried out, the results obtained that the motor can be controlled properly, the use of resistors with a certain amount (220 ohms) can increase the resulting motor rotation and at what voltage the motor starts to spin at a voltage of 0.436 volts, and continues to increase and the maximum voltage recorded at 6.40 Volts.</p><p><strong>Intisari</strong></p><p>Banyak hal yang dapat mempengaruhi kemampuan seseorang dalam merancang kendali motor DC, salah satunya adalah berkembangnya ilmu pengetahuan, khususnya ilmu komputer, Penggunaan algoritma untuk mencapai efektifitas pergerakan motor DC menjadi hal yang sangat diperlukan saat ini, sehingga robot dapat bergerak dengan baik dan sesuai dengan yang diinginkan. Algoritma memerlukan beberapa informasi dari sistem yang dibangun baik itu sebagai masukan maupun keluaran sehingga algoritma dapat melakukan proses pengendalian dengan baik. Pada penelitian ini telah dirancang rangkaian pengendali kecepatan motor dengan menggunakan transistor IR630, potensiometer digunakan sebagai masukan analog pada mikrokontrol dan kemudian dirubah menjadi sinyal PWM yang akan digunakan sebagai masukan pada rangkaian pengendali untuk menggerakkan motor DC. Pada pengujian yang telah dilakukan, hasil yang didapat bahwa motor dapat dikendalikan dengan baik, penggunaan resistor dengan besaran tertentu (220 ohm) dapat mempengaharui putaran motor yang dihasilkan dan pada tegangan berapa motor mulai berputar pada tegangan 0.436 V, dan terus meningkat dan tegangan maksimal yang tercatat sebesar 6.40 V</p> ER -